V2 JEDI-L User Manual

ENGLISH
20
 PLEASE NOTE: To select the button to be used to control the automation system, please refer to section “5. Selecting the
remote control button”
DELETING REMOTE CONTROL UNITS
MEMORISING REMOTE CONTROL UNITS
The device can memorise up to 15 remote control units. To memorise a remote control unit, proceed as follows:
Press the key
00
appears on the display
after approx. 1 second
Release the key and press the remote control button
twice: the device emits a BEEP and the display is turned
off to confirm memorising has been successful
Press and hold key :
00
appears on the display
after approx. 1 second
Hold the key until the display is turned off : the remote
controls have been deleted.
9
.End programming
To exit the programming and store the settings of the different parameters, it is necessary to follow this procedure:
P
ress the + key until the
display shows
II
Press and hold the key
for 5 seconds:
II
flashes
Release the key: the
s
egments of the display
illuminate one at a time
until showing
00
Display Reason
L
The display shows the letter L when the actuator is working normally and the red cam positioned on the chain activates
the micro switch on the motor
F The display shows the letter F when the door encounters an obstacle
H The display shows the letter H when the encoder or the control unit is malfunctioning
A The display shows the letter A when the photocell intervenes
DISPLAY MESSAGES

V2 JEDI-L Specifications

General

Brand	V2
Model	JEDI-L
Category	Controller
Language	English