Val Controls IDC24-A User Manual

DID-UM-002
Val Controls A/S • Limfjordsvej 3 • DK-6715 Esbjerg N • Tel. +45 7547 0600
vc@valcontrols.com • www.valcontrols.com
Revision: 10
26/74
Figure 17: Minimum breakaway pressure
6.3 Solenoid test
The solenoid test performs a movement or pressure drop of the system to verify the operation of the
solenoid operated valve, SOV. The test can be initiated from the test menu, a communication
protocol or a digital input depending on the configuration.
System without pressure sensor: System is detecting movement in the system to verify SOV
performance.
System with pressure sensor: System is detecting pressure drop in the system to verify SOV
performance.
Below is a signature from a typical solenoid test shown, including definitions on the different terms
further used in this manual.

Val Controls IDC24-A Specifications

General

Brand	Val Controls
Model	IDC24-A
Category	Controller
Language	English