24
Installation
Fuel Beds
Driftwood Kit 739DWK
Material required
• Driftwood Kit, which contains:
• 5 logs
• ceramic platform
• 6 pebbles
• Gloves, if desired
Installation
Unpack the driftwood kit very carefully to avoid
damaging the fragile material. Install the components
as shown below. Please note that the position of the
logs and pebbles (if used) is critical to ensure proper
performance of the appliance.
Platform
Place the platform into the firebox on top of the burner.
Rear Log
Base Log
Front Log
Right Side
Cross Log
Left Side
Cross Log
Ceramic Platform
Logs
1. Identify the base log and place it in the cavity of the
ceramic platform. The protruding parts of the log in
the front should rest against the lip of the fuel bed
support behind the burner.
2. Identify the rear log and place it on top of the base
log locating it into the notches on top of the log. Pull
the log forward so it is locked in position.
Pebbles
To Next Page
Loading...
Need help?
General
