Vatech EzSensor Classic User Manual

59
A.2 Error Message
1. USB device driver is not installed.
● Solution: Please install the device driver again.
2. Control box cannot be initialized.
● Solution: Check and re-connect the USB PC cable.
3. USB device driver is not working properly.
● Solution: Re-install the driver.
4. Capture program is already running.
● Solution: Please close any other programs.
5. Detector response time-out.
● Check and re-connect the USB PC cable. Please try again.
If the same message is displayed again, contact Customer Service.
6. Data communication error.
● Solution: Re-connect the USB PC cable.
7. Canceled image capturing.
●This means that the user canceled image capture. Please try again.
8. Cannot find dark frame.
●Solution: Restore the EzSensor Classic’s calibration data from the S/W installation CD
or re-calibrate the sensor. If the same message is displayed again, contact Customer
Service.
9. Cannot find bright frames for calibration.
● Solution: Reinstall the EzSensor Classic driver.
10. Bad Pixel Map correction error.
●Solution: Restore the EzSensor Classic’s calibration data from the S/W installation CD
or re-calibrate the sensor. If the same message is displayed again, contact Customer
Service.

Vatech EzSensor Classic Specifications

General

Brand	Vatech
Model	EzSensor Classic
Category	Medical Equipment
Language	English