Using the machine as a handheld
IMPORTANT: The handheld is to be used with water only, putting detergent into the water tank can cause damage.
Always check the tools are clean and free from debris, don’t use if damaged, broken or worn.
Push handle release button and lift
handle to remove . The collar should be
gripped with one hand when releasing
the handle with the other hand.
Push concentration nozzle into steamer
until it clicks into place.
Press accessory release button and lift
steamer to release oorhead.
Plug into mains, turn the dial to ‘on’
position. The red light will illuminate to
indicate power on.
To produce steam squeeze the trigger in short bursts. Don’t hold the trigger
continuously to prevent over wetting. Allow 30 seconds for steamer to
warm up. No sound will be heard until trigger is pressed. No steam will be
visible until after 30 seconds.
Twist the steam control dial to
desired setting.
Using your machine
Always switch OFF the
steamer before attaching
the concentration tool and
accessories.
CAUTION
To Next Page
Loading...
Need help?
General
