Remove oorhead and handle
and place steamer on at
surface. Twist water tank
cap anti clockwise and lift
to remove.
Correct
Incorrect
Do not ll directly from tap
or over sink. Keep steamer
on at surface. Use the
measuring jug and ll the
tank with 330ml (2 x 165ml)
of water.
Replace cap, align tabs
and twist clockwise
to tighten.
IMPORTANT
• Never turn the steamer over when water is in the tank, as some water may leak through the air valve.
It is normal for the water tube to make a rattling sound inside the water tank during use.
Cleaning hard oors
Place the microbre pad on the
oor white side facing up. Place the
oorhead onto microbre pad making
sure the microbre pad covers the
entire oorhead.
Plug into mains, turn dial to ‘ON’;
the red light will illuminate to indicate power
on. The steamer will be ready after
approximately 30 seconds. There will be no
sounds for the rst 30 seconds whilst it is
heating up.
To steam your oors twist the steam
control dial to desired setting. Steam
is activated automatically. Take
care when changing settings
during cleaning.
Place foot onto the oorhead and
pull handle backwards to recline.
Turn dial to ‘OFF’ position and allow
steamer to cool, the amber light will
switch o. Hold corner of pad down with
your foot and lift steamer to peel away.
IMPORTANT
• Never use the steamer without a microbre cleaning pad attached to the oorhead.
• Never leave the steamer on one spot for an extended period of time or with a damp or wet microbre pad attached as this
may damage the oor surface.
Move the steamer slowly backwards
and forwards across the oor paying
particular attention to high trac areas.
Using your machine
TIP
The water tank cap
has lock and unlock
padlock symbols.
To Next Page
Loading...
Need help?
General
