EasyManuals Logo
Home>Vector>Remote Starter>START-IT VEC022DSCC

Vector START-IT VEC022DSCC User Manual

Vector START-IT VEC022DSCC
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
SAFETY INFORMATION
WARNING: Warning statements identify conditions or practices that may result in
personal injury or loss of life
1. When working with lead acid batteries, always make sure immediate
assistance is available in case of accident or emergency.
2. Always use protective eyewear when using this product: contact with battery
acid may cause blindness and/or severe burns, be aware of first aid
procedures in case of accidental contact with battery acid.
3. There is a risk of explosive gases being released when lead acid batteries
are being charged or discharged. Failure to follow instructions may cause
property damage, explosive hazard, and/or personal injury.
4. When connecting the battery clamps to a discharged battery, and an alarm
sounds - the polarity is reversed.
5. When charging unit from a 110/120 Volt AC electrical outlet in any wet or
damp area, make sure that the outlet used is protected by a ground fault
interrupt (GFI) Switch.
6. When charging the unit near water, do not allow the electrical cords and
outlets to get wet or come near water–electrical shock could result.
7. Jump-start procedures should only be performed in a safe, dry, well-
ventilated area.
8. Always store battery clamps on clamp tabs when not in use. Never touch
battery clamps together, this can cause dangerous sparks, power arcing
and/or explosion.
9. When using this unit in proximity to the vehicle’s battery and engine, stand
the unit on a flat, stable surface, and be sure to keep all clamps, cords,
clothing and body parts away from moving vehicle components.
10. Do not wear vinyl clothing when jump-starting a vehicle, friction can cause
dangerous static-electricity sparks. Remove all jewelry or metal objects that
could cause short circuits or react with battery acid.
11. Always disconnect the negative (Black) jumper cable first: followed by the
positive (Red) jumper cable, except for positive ground systems.
12.
Never allow red and black clamps to touch each other or another common
metal conductor–this could cause damage to the unit and/or create
sparking/explosion hazard. Always store battery clamps on built-in clamp tabs
when not in use.
13. Do not expose battery to fire or intense heat as it may explode. Before
disposing of the battery, protect exposed terminals with heavy-duty electrical
tape to prevent shorting (shorting can result in injury or fire).
14. Do not smoke or use inflammable items (matches, cigarette lighters, etc.)
while working on a vehicle’s battery system.
15. Keep unit out of reach of children (whether stored, or in use)!
FIRST AID: SKIN: If battery acid comes in contact with skin, rinse immediately
with water, then wash thoroughly with soap and water. If redness,
pain, or irritation occurs, seek immediate medical attention.
EYES: If battery acid comes in contact with eyes, flush eyes
immediately, for a minimum of 15 minutes and seek immediate
medical attention.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vector START-IT VEC022DSCC and is the answer not in the manual?

Vector START-IT VEC022DSCC Specifications

Battery IconBattery
battery typesealed, lead-acid, rechargeable, maintenance-free, 12 volt DC
boost ampere450 instantaneous cranking amps
Charging Adapters IconCharging Adapters
DC charging adapter12 volt DC
AC charging adapter110/120 volt AC (700mA, 12 volt DC output)
accessory outletself-resetting breaker 5 amps DC
Booster Cables IconBooster Cables
booster cablesheavy duty cable
copper clamps450 amp
Lighting IconLighting
area lightcold cathode fluorescent lamp (CCFL)

Related product manuals