3/2002
G-3
INITIAL SET-UP
A. UNPACKING
Remove all plastic film, cardboard and tape from the outside of the vendor. Loosen
any shipping devices used to secure interior parts during shipment (backspacer,
shims or spacers).
To remove shipping boards from base, raise vendor on a well-stabilized lifting
device. Remove the leveling bolts which hold the boards in place and remove the
boards. Replace bolts to equal heights in the threaded holes.
Another method to remove shipping boards is to split the boards apart. Using a
pinch bar or a heavy screwdriver and hammer, insert tool into the slots and force the
boards apart.
B. POSITIONING
IMPORTANT: PLACE THE VENDOR IN DESIRED LOCATION AT LEAST THREE
TO FOUR INCHES (7.6CM TO 10.2CM) AWAY FROM ANY REAR
OBSTRUCTION. This is for proper air flow through the refrigeration compartment.
The refrigeration system requires front to rear air circulation for proper operation.
C. POWER SUPPLY CONNECTION
CAUTION: DO NOT USE AN EXTENSION CORD!
The vendor’s power requirements will vary depending upon the country it was
purchased for. To verify the power requirements of the vendor, check the serial
plate located on the hinged side of the outer door (see Figure 4 on page G-4). The
power requirements are listed on the serial plate.
To insure safe operation of the vendor, the vendor’s power supply must be a
properly grounded and polarized outlet. Before plugging the vendor into the outlet,
test the outlet to confirm it will meet the vendor’s power requirements. If the power
supply of the outlet is different from the power requirements of the vendor, a
transformer may be necessary.
If the power requirements are not properly met, contact a licensed electrician and
have the necessary correction made.
Should you require additional information, contact the Technical Services
Department of the Vendo office in your area.
To Next Page
Loading...
Need help?
General
