ENG VIVAX
23
USING THE REMOTE CONTROL
• Turning your TV on and off
Turning off to standby mode: Press [ ( | ) Power Standby] on the bottom panel
or on the remote control to switch to standby mode. You can activate the unit
again by pressing [ ( I ) Power Standby].
Power indicator: Light indicates standby mode. There will be no light when
the power switch is in the off position.
►NOTE
Remove the connection from the wall power outlet if you do not intend to use the unit for
long periods, for example if you plan to be away a few days. Wait at least 5 seconds after
turning off if you want to re-start the TV.
• Selecting the Input Source
Select the Input Source depending on the video device you have connected
to your TV.
To select the Input Source: Press [SOURCE] button. When the list of Input
Source appears, press [▲/▼] to select the source, then Press [OK] to
connect.
• Adjusting the volume
Press [VOL▲/VOL▼ ] to increase or decrease the volume.
Press [ MUTE ] to turn the sound off. Press [ MUTE ] again to turn the sound
back on.
• Changing channels
Press the [CH ▲/CH ▼] buttons to go to the next higher or lower channel. Or,
Press the number buttons to select a channel. For example, to select channel
12, press [1], then press [2].
• Selecting the aspect ratio
Press the [ZOOM] button to change the screen aspect ratio among Normal,
4:3, Wide, Zoom and Cinema
► NOTE
The option of aspect is varry with different source.
• Setting the sleep timer
You can specify how long you want your TV to wait for before it automatically
turns off.
Pressing [SLEEP] button repeatedly will allow you to change the sleep timer
mode: Off, 10Min, 20Min, 30Min, 60Min.
To Next Page
Loading...
Need help?
General
