23
57. Undo the screws and remove the oil sump. Then
remove the two screws in the lubricating oil pump
and lift out the pump with the pipe.
58. Remove the rubber ring for the oil pipe from the
cylinder block (And from the pipe where neces-
sary).
59. Note that the crankshaft and the crankshaft bear-
ing caps are numbered. Then remove the bearing
caps and remove the bearing shells.
60. Press out of the pistons from the cylinders. Let
the pistons fall on a soft surface so that they can-
not be damaged. Then remove the piston rings.
Use piston ring pliers.
To Next Page
Loading...
Need help?
General
