EasyManuals Logo
Home>Volvo Penta>Outboard Motor>D2 Series

Volvo Penta D2 Series User Manual

Volvo Penta D2 Series
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
Gauges
Tachometer
The tachometer shows engine speed; multiply the
value shown on the dial by 1,000 to get the number of
engine revolutions per minute.
Operating information is displayed in the tachometer
window.
Operating information symbols
1 Pre-heating
The pre-heat symbol is displayed when the glow
function is active.
2 Starting
The start symbol is displayed when the start motor
is engaged.
3 Stopping
The stop symbol is shown when the stop button is
depressed.
4 Fuel level
If a fuel level sensor is installed (accessory) the fuel
level symbol is displayed when there is around 20%
of fuel remaining in the tank.
The engine must run for at least one minute before
the function is activated.
5 System fault
The system fault symbol lights up in the case of
short circuits or cable breaks.
6 Auxiliary alarm
Auxiliary alarm for accessory sensors.
7 Coolant temperature
The coolant temperature symbol lights up if the
engine coolant temperature is too high.
8 Oil pressure
If the oil pressure lamp lights up during operations,
the engine oil pressure is too low.
9 Charging
The charging lamp lights up if the alternator stops
charging.
AUX
1
2
3
4
5
6
7
8
9
0
3
2
1
4
RPMX1000
P0007517
Instruments and Controls
47711262 01-2019 © AB VOLVO PENTA 23

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Volvo Penta D2 Series and is the answer not in the manual?

Volvo Penta D2 Series Specifications

General IconGeneral
BrandVolvo Penta
ModelD2 Series
CategoryOutboard Motor
LanguageEnglish

Related product manuals