9
884 231-2 Puller (center screw and puller nut are
used to withdraw liners)
884 359-1 Drift for installing seal in flywheel hous-
ing
884 551-3 Puller (caliper from the puller is used to
withdraw liners)
884 596-8 Drift for installing primary shaft in fly-
wheel housing
884 599-2 Drift for installing seal in flywheel hous-
ing
884 608-1 Puller for the polygon hub in the crank-
shaft
884 635-4 Removal punch for oil cooler insert
884 888-9 Plate liner puller
884 895-4 Lock pin for flywheel, pump setting
884 931-7 Puller for injector sleeve (31, 32, 41, 42,
43)
884 945-7 Drift for installing injector sleeve (31, 32,
41, 42, 43)
884 992-9 Reamer (valve guide) (31, 32, 41, 42, 43)
885 128-9 Valve spring tensioner
885 131-3 Puller for dismantling injector nozzle
(31, 32, 41, 42, 43)
Special tools
In all cases where it is practical the tool number, except for the final digit, has been stamped on the tool.
The final digit (after the hyphen) is a control number.
884 635884 599
884 888
884 231 /
884 551
884 945
884 596
884 931
884 359
884 992
884 608
885 128884 895 885 131
To Next Page
Loading...
Need help?
General
