VTech VS 113-5 User Manual

46
47
After speaking, release PTT on your
handset or PTT/FLASH on your
telephone base. Your device will beep.
After the beep, if your speakerphone
light is off, you can press and hold PTT
on your handset or PTT/FLASH on your
telephone base to continue speaking, or
the destination device can respond.
Change a one-to-one PTT call to an
intercom call
You can convert a one-to-one PTT session
to an intercom call.
1. When your device shows Press [PTT]
Talk, press MENU/SELECT. The screen
shows Intercom.
2. Press MENU/SELECT. Your device
displays Calling base or Calling HS
X. The destination device shows
HANDSET X is calling or BASE 0 is
calling. The destination device rings.
3. Press HOME/FLASH, CELL, or
on the destination handset,
or press HOME or CELL on
the telephone base to answer the
intercom call. Both devices now show
Intercom.
4. To end the intercom call, press
OFF/CANCEL on your handset or
place the handset in the telephone
base or charger, or press CANCEL
on the telephone base. Both screens
show Intercom ended.
Answer an incoming call during a PTT call
When you receive an outside call during
PTT, there is an alert tone.
• During a one-to-one PTT, press
HOME/FLASH, CELL, or on
the initiating or destination handset.
The PTT call ends automatically and
the outside call is answered.
• During a one-to-group PTT call, press
HOME/FLASH, CELL, or on
the initiating handset, or HOME
on the initiating telephone base. The
PTT call ends automatically and the
outside call is answered.
• During a one-to-group PTT call,
press HOME/FLASH on any one
of the destination handsets, or press
HOME on the destination
telephone base. That device answers
the outside call. The PTT call continues
for the rest of the PTT participants.
• To leave the PTT call without answering
the incoming call, press OFF/CANCEL
on your handset or CANCEL on your
telephone base. The telephone
continues to ring.
Make an outgoing call during PTT call
• During a one-to-one PTT call, press
HOME/FLASH on your handset
or HOME on your telephone base
to get a dial tone. The PTT call ends
automatically.
• During a one-to-group PTT call,
press HOME/FLASH on the
initiating handset or HOME on
the initiating telephone base. The
PTT call ends automatically and you
get a dial tone.
• During a one-to-group PTT call,
press HOME/FLASH on any one
of the destination handsets or press
HOME on the destination
telephone base.That device gets a
dial tone. The PTT call continues for
the rest of the PTT participants.
End or leave a PTT call
For one-to-one PTT calls, both initiating
and destination devices can end the
PTT call. For PTT calls to multiple devices,
the initiating device can end the PTT
call. If any one of the destination devices
leaves the PTT call, the call continues
until all participants or the initiator hangs
up.
Press OFF/CANCEL on the handset, or
press CANCEL on the telephone base.
The screen shows Push to talk Ended.
-OR-
Place the handset in the telephone base
or charger, then the handset returns
to idle mode.
NOTE
• After PTT on the handset or
PTT/FLASH on the telephone base is
released, the PTT call remains open
for a short time. If no one presses PTT
on the handset or PTT/FLASH on the
telephone base within ten seconds,
the PTT call ends automatically.

VTech VS 113-5 Specifications

General

Brand	VTech
Model	VS 113-5
Category	Telephone
Language	English