The charge capacity of rechargeable
batteries will reduce with time as they
wear out, so reducing the talk/standby
time of the handset. Eventually they
will need to be replaced. New batteries
are available from the VT1030 Helpline
on (852) 2776 3223.
Batteries and handset may become
warm during charging. This is normal.
Your VT1030 uses the
24 hour clock.
If you have more than one handset
registered to your base, you only need
to set the date and time on one
handset and the other handsets will be
automatically updated.
Set the date and time format
1. Press the Left soft key
to open the main menu.
2. Press or until the display shows
HS SETTINGS
and
press
OK
soft key.
DATE & TIME
is displayed, press the
OK
soft
key again.
3.
DATE FORMAT
is displayed, press the
OK
soft key and the
current format is displayed. Press or to change
between
DD-MM-YY
and
MM-DD-YY
. Press the
OK
soft key,
you will hear a confirmation tone.
4. Press and
TIME FORMAT
is displayed. Press the
OK
soft
key and the current format is displayed. Press or to
change between 24hr and 12hr. Press the
OK
soft key, you
will hear a confirmation tone.
5. Press and hold the
soft key to return to standby.
Getting started
3
To Next Page
Need help?
General
