BPU 2440/2950 Repair General Information
wc_tx000264gb.fm 11
3. General Information
3.1 Application
Due to its low width of only 400 or 500 mm and its infinitely variable
working speed setting, this vibratory plate is particularly suited for all
kinds of soil compaction in confined areas such as in cable trenches
40 cm wide or more, compaction of marginal strips, repairs on blacktop
surfaces as well as for all compaction jobs where the use of large scale
equipment is not suitable. Do not use this machine for any other
purpose.
3.2 Tools
Since all possible problems encountered while repairing the
equipment cannot be anticipated, it is up to the mechanic to use
common sense and good judgment in tool selection.
The use of any special tools is recommended only for those operations
where the use of conventional tools proves inadequate.
Before substituting another tool or procedure, you should be satisfied
that neither personal injury nor damage to the component will result.
3.3 Ordering Parts
Operating / Parts Information
You must be familiar with the operation of this machine before you
attempt to troubleshoot or make any repairs to it. Basic operating and
maintenance procedures are described in the operator’s / parts
manual supplied with the machine. The operator’s / parts manual
should be kept with the machine. Use it to order replacement parts
when needed. If this manual becomes lost, please contact Wacker
Corporation to order a replacement.
Damage caused by misuse or neglect of the unit should be brought to
the attention of the operator, to prevent similar occurrences from
happening in the future.
To Next Page
Loading...
Need help?
General
