Wacker Neuson BS 60-2 Repair Manual

Engine and Upper Machine Components Repair
34 wc_tx001546gb.fm
4.5 Replacing the Stop Switch (2-stroke models, 2010 and later)
Requirements
• Machine shut down and cool
• Torque wrench
Removal
Perform the procedure below to remove the stop switch.
4.5.1 Remove the silencing cover. See topic Replacing the Silencing Cover.
4.5.2 Remove the throttle control. See topic Replacing the Throttle Control.
4.5.3 Remove the two screws
(a) the hold the fuel valve to the throttle
control bracket. Allow the fuel valve (b) to hang by the fuel hoses.
4.5.4 Disconnect the stop switch wiring
(c) from the engine.
4.5.5 Remove the clamp
(d).
This procedure continues on the next page.
wc_gr007463
a
wc_gr007462
b

Wacker Neuson BS 60-2 Specifications

General

Brand	Wacker Neuson
Model	BS 60-2
Category	Vibratory rammers & tampers
Language	English