User’s Manual Pulse • PulsePlus
49
MIDI Device ID
CV/Gate Parameters
CV/Gate Channel
When this parameter is set to Off, the Pulse sends out the played notes via CV
1 Out 쐋 and Gate Out 쐄. An incoming control voltage at CV In 쐃 and Gate
In 쐇 triggers the sound generation of the Pulse.
When the parameter is set to 1...16, the CV/Gate interface is operating
independently. Received notes on the selected Channel are sent out as control
voltages via CV 1 Out 쐋 and Gate Out 쐄. Incoming control voltages at CV In
쐃 and Gate In 쐇 are transformed into notes and sent on the selected channel.
The internal sound generation will not be affected.
CV In Adjust
To proceed the adjustment, connect the CV output of the keyboard to the CV In
input 쐃 of the Pulse. Connect the Gate jacks in the same way. Now adjust the
parameter to a value, that causes the Pulse to generate a proper tune on the
played notes.
Please note that the CV In input can operate with linear scaled control voltages
of 1V/Octave only.
Adjust parameter for the CV In input.
-64...+63
Example: Channel 3
Off
MIDI send and receive channel for the CV/Gate
interface
Off, 1...16
Device-ID for system exclusive data transmission.
0...126 Preset value is 0
To Next Page
Loading...
Need help?
General
