Wavecom TnP Prime User Manual

37
TnP Prime User Manual Wavecom
Dump mode
Printer will enter dump mode after printing printer configuration. In the dump mode, all characters will be
printed in 2 columns as following. The left side characters are received from your system and right side data
are the corresponding hexadecimal value of the characters. It allows users or engineers to verify and debug the
program. Dump mode requires 2” wide paper width.
Note:
1. Turn off / on the power to resume printer for normal printing.
2. Press FEED button to go back to the previous menu.
Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults. Printer initialization is
activated by the following procedures.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green after 5 amber flashes. (Any green will do during the 5 flashes).
• The LED colour will be changed as following:
1. Amber
2. Red (5 flashes)
3. Amber (5 flashes)
4. Green (5 flashes)
5. Green/amber (5 flashes)
6. Red/amber (5 flashes)
7. Solid green
Printer configuration will be restored to defaults as below after initialisation.
Parameter Default setting Parameter Default setting
Speed
127 mm/sec (5 ips) (203DPI) 76.2
mm/sec (3 ips) (300DPI)
Tear Mode On
Density 8 Peel off Mode Off
Label Dimensions 2” (50.8 mm) x 2” (50.8 mm) Cutter Mode Off
Sensor Type Gap sensor Serial Port Settings
9600 bps, none parity, 8 data
bits, 1 stop bit
Gap Setting 0.12” (3.0 mm) Code Page 850
Print Direction 0 Country Code 001
Reference Point 0,0 (top left corner) Clear Flash Memory No
Offset 0 IP Address DHCP

Wavecom TnP Prime Specifications

General

Brand	Wavecom
Model	TnP Prime
Category	Test Equipment
Language	English