Windsor Clipper CLP12 Operator Instructions

OPERATIONS
CLIPPER 86038240
3-6
Remove electrical cord and literature from
recovery tank. Fill solution tank (see filling
instructions page 3-5).
Adjust brush to proper setting. Note: For
good operation the brush must skim the
carpet. If circuit breaker trips raise brush to
prevent damage to motor or carpet.
Plug cord into grounded outlet. Note: Be sure
dome is seated on recovery tank, and float
shut-off is installed correctly.
Turn on brush and vacuum motor switches
(“ON”=“I”). Turn on solution switch for
continuous spray or set switch to intermittent
to allow use of trigger switches.
STEP
1
STEP
2
STEP
3
STEP
4
SOLUTION VACUUM
CONT
INT
BRUSH
ON
ON

Windsor Clipper CLP12 Specifications

General

Brand	Windsor
Model	Clipper CLP12
Category	Floor Machine
Language	English