Windsor Clipper CLP12 Operator Instructions

MAINTENANCE
CLIPPER 86038240
4-2
PERIODIC MAINTENANCE
Twice a month, flush a white vinegar solution (One quart
vinegar to two gallons of water) or anti-browning solution
(mixed as directed) through the extractor. This will prevent
build-up of alkaline residue in the system. If spray jets
become clogged, remove the spray tips, wash them
thoroughly, and blow-dry.
NOTE: Do not use pins, wire, etc. to clean nozzles as this
could destroy spray pattern.
Periodically inspect all hoses, electrical cables and
connections on your machine. Frayed or cracked hoses
should be repaired or replaced to eliminate vacuum or
solution pressure loss. If the cable insulation is broken or
frayed, repair or replace it immediately. Don’t take chances
with electrical fire or shock.
DAILY / REGULAR MAINTENANCE
Before making any adjustments or repairs to the machine,
disconnect the power cord from electrical source.
1. Empty unused cleaning solution from the solution tank.
2. Inspect and clean filter screen in solution tank.
3. Flush pumping system with 4 or 7 liters of clean, hot
water.
4. After each use, rinse tank with fresh water. Periodically
inspect the recovery tank and decontaminate if
necessary, using a Hospital Grade Virucide or a 1-10
bleach to water solution. Waste water should be
disposed of properly.
5. Check for and remove any lint or debris around vac
shoe.
6. Check spray jets for full spray pattern.
7. Remove lint and dirt build-up from brush and housing.
NOTE: Brush removal.
A. To remove brush, grab and pull brush out from end
opposite drive belt (operator’s right). Remove other
end from brush driver.
B. To install brush, line up slots in brush core with pin
in driver on drive belt side (operator’s left) and push
brush onto driver. Then snap bearing end (opposite
end) of brush into retaining clip.
8. Check cooling air screen (located on frame behind left
wheel) for lint or debris.
9. Check float and shut-off screen and clean as necessary.
NOTE: Always store machine with brush in “Store” position.

Windsor Clipper CLP12 Specifications

General

Brand	Windsor
Model	Clipper CLP12
Category	Floor Machine
Language	English