Winterhalter GS 600 Series User Manual

89007105 7
7 Before washing
Turn water stop valve to open position.
Switch on the mains disconnecting device (mains switch) provided by the customer.
Check level in rinse additive container and detergent container (only with automatic
detergent dosage).
Replace or fill up empty containers.
Observe safety instructions on packaging.
Check whether the flat filters, the basket filter and the filter in the floor of the tank
(drainage filter) are installed.
Do not load wash items at this stage.
Close door.
Press On/Off switch (1), heating up phase begins.
Programme button is lit red: the tank is filled in stages over the boiler and
heated up.
Programme button is lit green: Filling and heating up phase completed.
Door must remain closed during filling / heating up.
Open door.

Winterhalter GS 600 Series Specifications

General

Wash cycle time	90/120/180 sec
Water consumption per cycle	2.4 l
Power Supply	400V, 3-phase, 50Hz
Water Consumption	2.4 liters per cycle
Wash Programs	Standard, Intensive

Summary

Intended Use

Safety Instructions

Machine Setup and Commissioning

Installation and Connection

Details requirements for water, drainage, electrical connections, and initial checks.

Commissioning

Steps for initial startup and operator training by Winterhalter service.

Washing Operation and Programmes

Functions of the Utensil Washer

Wash Programmes

Before Washing

Detergent Dosage

Explains manual and automatic methods for adding detergent.

Washing Procedure

Loading and Washing Items

Post-Wash Procedures

After Washing and Switching Off

Maintenance and Care

Routine Maintenance

Malfunctions and Troubleshooting

Self-Remedial Malfunctions

Guides on resolving common issues that users can fix themselves.

Malfunctions Requiring Service

Identifies faults that necessitate contacting Winterhalter customer service.