Notifications | 7 | English
Operating instructions UC-Serie | 89014383; Version 2 | 39
7 Notifications
7.1 Pictograms
Notifications are displayed as pictograms. If there are many notifications, washing will still be possible but the end wash
result will be impaired. Please therefore rectify any notification as soon as possible. If you cannot rectify the notification,
contact an authorised service technician.
By tapping the pictogram, additional information will appear on the display.
Cause / meaning Remedy
Lack of rinse aid
Fill integral storage tanks (} page 44) or replace the canister (}
page 45) and prime the dosing device.
Lack of detergent
Upper wash field does not rotate
Remove the obstruction or clean or descale the jet (} page 41).
Contact an authorised service technician.
Lower wash field does not rotate Ensure the wash field is engaged correctly.
Remove the obstruction or clean or descale the jet (} page 41).
Contact an authorised service technician.
For warewashers with an integrated softener:
Lack of salt
Fill the salt container with regeneration salt. The display disap-
pears after filling the salt container after approx. 3 wash cycles
have been completed and some of the salt has dissolved.
Warewasher with external partial demineralisa-
tion cartridge:
Partial demineralisation cartridge used up
Replace the partial demineralisation cartridge. Reset the water
countdown meter (} page 24).
Warewasher with external full demineralisation
cartridge:
Full demineralisation cartridge used up
Have the resin of the full demineralisation cartridge replaced by
an authorised service technician. Reset the water countdown
meter (} page 24).
Open the door Close the door.
Lack of water Open the water supply.
Have the dirt trap cleaned by a service technician or have a new
dirt trap installed.
Have the solenoid valve repaired by an authorised service techni-
cian.
Energy optimisation active Wait until the local energy optimisation activates the warewasher.
Service interval expired Contact an authorised service technician.
Strainer clogged Clean the strainer and restart the programme.
Descaling required
Start the descaling programme (} page 22).
Error in external water treatment device Check the water treatment device.
Energy saving warning Close the door.
Various Tap the pictogram and note the error code. Contact an authorised
service technician.
Reverse osmosis deactivated Contact an authorised service technician.
Activated carbon filter used up
Change the activated carbon filter (} page 46) and reset the ac-
tivated carbon counter (} page 24).
A0-30 wash cycle cancelled Hygiene in accordance with A0 requirements not guaranteed. Re-
start the A0 washing programme.
A0-60 wash cycle cancelled
To Next Page
Loading...
Need help?
General
