76
EC-declaration of confirmity
We herewith declare, Woodster GmbH, Günzburger Str. 69, D-89335 Ichenhausen that the machine described below due to its con struc tion and design and in the version
delivered by us complies with the relevant provisions of the following EC Directives.
In case of a modification of the machine this declara tion ceases to be valid.
Machine description:
Circular saw bench
Machine model:
st 10 l
2
, Art.-Nr. 390 130 4 000 / 390 1304 901 / 390 1304 908 / 390 1304 942
Relevant EC directives:
EC machine directive 2006/42/EG,
EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Applied harmonized European Standards:
EN 12100-1, EN 12100-2, EN 13857, EN349, EN418, EN1088, EN60204-1, EN55014, EN60555-2, EN 50082-1, EN60555-3, EN 61029-1, EN 61029-2-1, EN 60825-1
Applied european Standards:
EN 847-1, EN 13849-1
Applied national technical standards and specifications, especially:
ISO 7960
Notified body within the meaning of Annex VII
TÜV Rheinland
Engaged for
EC design examination
Date
Ichenhausen, 07.07.2009
Signature:
on behalf of Thomas Honigmann (Managing director)Trouble shooting
Problem Possible Cause Help
1. Saw blade releases when the motor
is turned off. s
Securing nut is not tightened
adequately. angezogen
Securing nut must be tightened with a
right hand thread.
2. Motor does not start a) Fuse safety blown a) Check the fuse safety.
b) Extension cord is defective b) Get a new extension cord
c) Connection to the motor or the
switch is defective.
c) Have an electrician check the
machine.
d) Motor or switch is defective. d) Have an electrician check the
machine.
3. Motor has an incorrect rotational
direction.
a) Defective capacitor a) Have an electrician check the
machine
b) Incorrect connection b) Let an electrician change the
polarity of the outlet
4. Motor does not get up to
speed,fuse blows.
a) Cross cut of the extension
connection is not adequate.
a) Check the electrical connection.
b) Overload due to a dull saw blade. b) Change the saw blade.
5. Burn marks on the cut a) Dull saw blade. a) Sharpen the saw blade, replace it.
b) Wrong saw blade b) Replace the saw blade.
To Next Page
Loading...
Need help?
General
