Owner’s Manual EN
17
Step 3: Enter the Landroid
®
APP, and then follow the instructions to connect to your Wi-Fi.
*The Serial No. can be found at the rear of Landroid
®
as shown (See Fig. H) .
NOTE:
1. If your Wi-Fi information changes, Landroid
®
needs to be re-set according to Step 3.
2. When Landroid
®
is located in an area with low or no Wi-Fi signal, instructions sent from the mobile App may not be
executed immediately. Landroid
®
will receive instructions when it returns to an area with good Wi-Fi signal.
3. For strong Wi-Fi signal to ensure stable connection, it is recommended to install Wi-Fi extenders to cover areas with
weak or no Wi-Fi signal.
7. Boundary Wire Basics
7.1 Pegging the Boundary Wire
Use the boundary wire distance gauge to set the correct distance
between the wire and the border of your lawn (more than 26cm).
This is the recommended distance. The provided distance gauge
ensures proper installation.
If your neighbor also uses a Landroid
®
, keep a spacing of at least 1
metre between your boundary wire and your neighbor’s.
The boundary wire must outline the intended mowing
area exactly. Your Landroid
®
will become confused by extra bends
or coils of boundary wire that are not part of its mowing area (See
Fig. I). If there is excess boundary wire after the mowing area has
been outlined, cut it off and store this additional wire in a separate
location. It is important to leave the necessary length where it
connects to the charging base so it can be connected and still
remain buried.
H
I
To Next Page
Loading...
Need help?
General
