Owner’s Manual EN
18
7.2 Burying the Boundary Wire
If you are planning to bury the boundary wire, it is recommended to first peg it down. This allows you to easily change the layout if
necessary before burying the wire. When the boundary wire installation is complete, have Landroid
®
follow and check the path by
pressing and . This allows your Landroid
®
to adjust to its new environment. .
While observing Landroid
®
you can easily make alterations to the boundary wire to ensure Landroid
®
's trouble-free tracking when
locating the charging station. Confirm that Landroid
®
docks in the charging station successfully, and bury the wire if desired.
7.3 Joining the boundary wire
If you want to extend and splice the boundary wire, use a connector. The connector is waterproof and provides optimal
connection.
Insert both wire ends in any two of the three holes of the connector. Insert the wires fully until both wire ends are visible
on the other side of the connector. (See Fig. J1) Press the connector together by using a pair of pliers. (See Fig. J2, J3)
WARNING! It is not recommended to simply splice the boundary wire with insulating tape or use a screw terminal
block for connection. A broken circuit may occur after a period of time as soil moisture can oxidize the wire.
8. Software update
The software can be updated when new versions become available. The latest software can be downloaded from our
website www.worx.com. There are two methods to update software.
Method 1: Update via USB. See below for download and installation instructions:
(1) Locate the latest software version at: www.worx.com. Save the file to an empty FAT32 formatted USB (flash drive).
Delete any other files on the drive and check the format. If the drive is not formatted in FAT32, please reformat the
drive.
NOTE: the software update is downloaded as a zipped file. You will need to unzip or extract it before proceeding.
J1
J2
To Next Page
Loading...
Need help?
General
