Locations to Avoid:
1. Near large metal surfaces and bundle of wire.
2. Near fluorescent lights, amateur radios, electrical equipment or other devices which may transmit
an RF signal, as electronic “noise” may cause nuisance alarms.
WARNING!
1. This alarm should be installed by a competent person.
2. Alarms should not be used as a substitute for proper installation, use and maintenance of fuel
burning appliances including appropriate ventilation and exhaust systems.
Installation Method
1. Use the mounting bracket to mark the screw holes on the ceiling or the wall.
2. Drill holes at the two marks using an appropriately-sized drill bit. Insert the anchor plugs and
screw the mounting bracket using the screws provided.
3. Attach the alarm to the mounting bracket and turn clockwise to lock the alarm.
4. Test the smoke alarm according to the steps in the section “Alarm Test”.
To Next Page
Loading...
Need help?
General
