Maintenance
To keep your smoke alarm in good working order, follow these simple steps:
1. Verify the unit's alarm sound and indicator are working properly by testing the unit once a week.
2. As a minimum your smoke alarm should be cleaned once every 3 months: Remove the unit from
the ceiling and clean the alarm cover and vents with your vacuum cleaner fitted with the soft brush
attachment to remove dust and dirt.
3. Never use detergents or other solvents to clean the unit.
4. Avoid spraying air fresheners, hair spray or other aerosols near the alarm.
5. Do not paint the unit. Paint will seal the vents and interfere with the sensor’s ability to detect fire.
6. Never attempt to disassemble the unit or clean inside. Doing so will void your warranty.
7. When removed, place the smoke alarm back in its proper location as soon as possible, to assure
continuous protection from fire.
8. When household cleaning supplies or similar contaminants are used, the area should be ventilated.
Troubleshooting
Your smoke alarm does not sound
during testing.
⚫ Please check whether the alarm is properly attached to the
mounting bracket.
⚫ Make sure you push the central test button firmly.
⚫ Check the installation positioning. The wireless signal
might be blocked or out of range.
False alarms triggered intermittently
or when residents are cooking,
taking showers, etc.
⚫ Check the location of your smoke alarm (see “Installation
Positioning”).
⚫ Clean the smoke alarm (see “Maintenance”).
Red LED flashes and the alarm
sounds one beef every 60 seconds.
The battery is low. Replace immediately.
Red LED flashes and the alarm
sounds two beeps every 40 seconds.
The detector is malfunctioning. Please clean your smoke
detector, or replace immediately.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with Local Authority or retailer for recycling advice.
35 m (over 250 m in clean air)
To Next Page
Loading...
Need help?
General
