3 Copy
42 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 Quick Reference Guide
If necessary, select one of the tabs and configure the copy settings. For information on
the individual tabs, refer to the following.
Basic Copying – page 43
Image Quality - Copy – page 50
Scan Options - Copy – page 52
Output Format - Copy – page 60
Job Assembly – page 69
3. Enter the Quantity
The maximum copy quantity is 999.
1. Use the numeric keypad to enter
the number of copies required.
The number entered is
displayed in the upper right
hand corner of the touch screen.
NOTE: To cancel an incorrect entry,
press the <C> button and enter the
correct quantity.
4. Start the Copy Job
1. Press the <Start> button. Each
document is scanned only once.
The number of copies remaining
is displayed in the upper right
hand corner of the touch screen.
While copying, if the document feeder or document glass is ready and the machine is
equipped with the optional hard disk, you can scan the next document or program the
next job. While the machine is warming up, you can also program the next job.
5. Confirm the Copy Job in the Job Status
1. Press the <Job Status> button
on the control panel to display
the [Job Status] screen.
<C> button
<Start> button
To Next Page
Loading...
Need help?
General
