7 Paper and Other Media
92 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 Quick Reference Guide
Supported Paper Types
The following table lists the paper types supported for each paper tray, duplex module,
and the finisher.
O: Available
X: Not available
• Plain: When using Arjo Wiggins Conqueror High Speed Laser Laid CON90F
(64010283), select [Heavyweight1] on the [Paper Type] screen.
• Side 2 Paper: Refers to the paper already printed on one side (i.e. scrap paper).
• Transparency: When using Xerox paper backed (3R3028) (for US) or 3M Type L
Desktop Laser (3R91334) (for EU) in low temperature and humidity (10
o
C, 15%)
select [Heavyweight1] on the [Paper Type] screen.
• If you select [Label], [Heavyweight 1] or [Heavyweight 2], load the paper LEF. If
loading the paper SEF, printed quality may be negatively affected.
• Lightweight: If you select [Lightweight], the machine lowers the temperature of the
fuser unit when printing. Select this option when paper curls or other pritning
problems occur due to high temperature in the fuser unit when it sets toner on the
paper.
• Heavyweight: Depending on heavyweight paper, the machine cannot load Short
Edge Feed. In that case, set the paper Long Edge Feed.
• Depending on the type of paper used and the operating environment, paper may not
feed to the machine properly, or print quality may be negatively affected.
Paper Type
Weight (g/m
2
)
Tray 1
Tray 2, 3–4
(Two Tray
Module/TTM)
Tray 5
(Bypass)
Duplex
Module
Finisher
Plain
60–105
OOOOO
Recycled OOOOO
Side 2 Paper* O O O X O
Transparency – O O O X X
Labels 60–105 O O O X X
Lightweight** – O O O X X
Heavyweight 1 106–169 X O O X X
Heavyweight 2 170–216*** X O O X X
To Next Page
Loading...
Need help?
General
