Xerox DocuPrint 203A User Manual

Troubleshooting
6 - 10
6
Other problems
For Macintosh
®
with USB
Improving the print quality
If you have a print quality problem, print a test page first (see page 4-8). If the printout looks good, the problem
is probably not the printer. Check the interface cable or try the printer on another PC.
This section provides information on the following topics:
Problem Recommendation
The printer cannot print. There
was an error writing to LPT1:
(or BRUSB) for the printer
error message occurs on your
PC.
 Check that the printer cable is not damaged or broken.
 If you have an interface-switching device, make sure the correct printer is
selected.
Problem Recommendation
The printer does not appear in
Chooser (Mac OS
®
9.1 to 9.2)
or Print Center (Mac OS
®
X
10.2.4 or greater).
 Check that the printer is turned on.
 Check that the USB interface cable is connected correctly.
 Check the print driver is installed correctly.
Unable to print from application
software.
 Make sure that the supplied Macintosh
®
print driver is installed in the Hard Disk
and that it is selected with Chooser (Mac OS
®
9.1 to 9.2) or Print Center (Mac
OS
®
X 10.2.4 or greater).
Examples of poor print
quality
Recommendation
Faint
 Check the printer’s environment. Conditions such as humidity, high
temperatures, and so on may cause this print fault. See Positioning the printer
on page 2-4.
 If the whole page is too light, Toner Save mode may be on. Turn off Toner Save
mode in the printer Properties tab of the driver.
 Try installing a new toner cartridge. See Replacing the toner cartridge on page
5-3.
 Try installing a new drum unit. See Replacing the drum unit on page 5-8.
ABCDEFGH
abcdefghijk
ABCD
abcde
01234
C
DE
F
d
ef
g
BC
b
c
d
2
3

Xerox DocuPrint 203A Specifications

General

Brand	Xerox
Model	DocuPrint 203A
Category	Printer
Language	English