Before using the machine
1 - 9
1
For consumables
Never throw a toner cartridge into an open flame. Toner remaining in the cartridge can cause an
explosion and you can get burnt.
Never use a vacuum cleaner when you clean spilled toner. It can cause explosion as the toner fills the
vacuum cleaner and gets sparks. Use a broom or a wet cloth.
Never heat the drum in a drum cartridge, or scratch its surface. A heated or scratched drum can be
hazardous to your health.
Be careful not to inhale the toner.
If your clothes are smeared with toner, wipe off the toner with a dry cloth and immediately wash the
clothes in cold water to avoid stains.
Radio interference (220-240 volt model only)
This printer follows EN55022 (CISPR Publication 22)/Class B.
Before you use this product, make sure that you use the following interface cables.
1. A shielded parallel interface cable with twisted-pair conductors and that it is marked "IEEE 1284 compliant".
2. A USB cable.
The cable must not be more than 2 meters long.
IEC 60825-1 specification (220 to 240 volt model only)
This printer is a Class 1 laser product as defined in IEC 60825-1 specifications. The label shown below is
To Next Page
Loading...
Need help?
General