Xerox Phaser 3300MFP User Manual

14.2 < Troubleshooting>
Roller misfeed
1 Open the scanner lid.
2
Grasp the misfed paper, and remove the paper from the feed area
by carefully pulling it to the right using both hands.
3 Close the scanner lid. Then load the removed pages back into the
ADF.
Clearing paper jams
When a paper jam occurs, Paper Jam appears on the display. Refer to
the table below to locate and clear the paper jam.
Caution
To avoid tearing the paper, pull out the jammed paper gently
and slowly. Follow the instructions in the following sections to
clear the jam.
Message Location of jam Go to
[Paper Jam 0]
Open/Close Door
In the paper feed area (tray 1,
optional tray 2, or multi-
purpose tray)
below and
page 14.3
[Paper Jam 1]
Open/Close Door
In the fuser area or around the
print cartridge
page 14.3
[Paper Jam 2]
Check Inside
In the paper exit area page 14.4
[Duplex Jam 0]
Check Inside
In the duplex unit page 14.5
[Duplex Jam 1]
Check Inside
Between the duplex unit and
fuser area
page 14.6
1
scanner lid
1
In tray 1
1 Open and close the front cover. The jammed paper is automatically
ejected from the machine.
If the paper does not exit, go to the next step.
2 Pull tray 1 open.
3 Remove the jammed paper by gently pulling it straight out.
If the paper does not move when you pull, or if you do not see the
paper in this area, check the fuser area around the print cartridge.
See page 14.3.
4 Insert tray 1 into the machine until it snaps into place. Printing
automatically resumes.

Xerox Phaser 3300MFP Specifications

General

Brand	Xerox
Model	Phaser 3300MFP
Category	All in One Printer
Language	English