DescriptionNameItem
Number
Use this button if the press has been inactive and the touch
screen is dark (system is in Energy Savermode). This button
manually exits the system from Energy Saver mode; it does
not place the press in Energy Save mode.
Power Saver button8
Use to enter alphanumeric characters. The ‘C’ Cancel Entry
cancels the previous entry made on the numeric keypad.
Numeric Keypad9
Use this button to cancel the previous entry made on the
numeric keypad.
Cancel Entry button10
Use this button to return all selections to the same state
as when the press was powered on. Press once to clear a
current entry. Press twice to return to default settings.
Clear All button11
Press to stop and pause the print job in progress.Stop button12
Press to start and print a selected report. Also used by the
Customer Service Engineer during diagnostic routine pro-
cedures.
Start button13
The three indicator lights that identify: data transmission
in progress, the press is experiencing an error, and main
power is on.
Press Status Lights14
Power Saver Mode
The Power Saver feature allows the press to enter a reduced power consumption mode
when all print jobs have completed and there are no jobs currently processing. There
are two power saving modes: Low Power and Sleep.
• Low Power: After remaining inactive for a preset time period, the press enters the
Low Power mode.
• Sleep: After entering Low Power mode and remaining inactive for another preset
time period, the press enters the Sleep mode.
By default, the press automatically enters the Low Power mode after 1 minute of
inactivity. After 1 minute of inactivity, the press then enters Sleep mode. These time
intervals for both modes can be changed by the system administrator.
Refer to the following example:
• Low Power Mode is set to 1 minute.
• Sleep Mode is set to 10 minutes.
• Sleep Mode activates after 10 minutes of total inactivity and not 10 minutes after
the Low Power Mode begins.
Xerox
®
Versant
®
3100 Press2-4
Quick Start Guide
Getting Started