User Guide 5-1
5. Loading Documents to Scan
Always remove any staples or paper clips from documents before inserting them into the scanner.
Staples and paper clips can jam the feed mechanism and scratch the internal components. Also
remove any labels, stickers, or Post-It™ notes that may come off during the scanning process and
get stuck in the scanner. Misuse as described here will void your scanner’s warranty. Please go to
www.xeroxscanners.com
, select your product, and then click the “Warranty” link to view the
warranty terms and conditions for your scanner.
Supported Document Types
You can scan the following types of documents with this scanner.
• Maximum amount of paper in the input tray
– Approximately 500 pages of 7 ~ 28 lbs (27~105 g/m
2
)
new printer paper
•Document size
– Minimum size (width x length)
– Single Page 1.97 x 2.56 inches (50 x 65 mm)
– Multi Page 1.97 x 3.35 inches (50 x 85 mm)
– Maximum size (width x length) – 12.1 x 17.0 inches (308 x 432 mm)
– Maximum length with long document enabled – 236.0 inches (5994 mm)
We recommend scanning one page at a time when the documents you are scanning are
longer than 17 inches (432 mm).
•Mixed document stacks
– Scanner minimum to maximum without long document enabled
Arrange the documents so that all items are centered in the stack. The document sensor,
paper separation, and feed rollers are located in the middle of the paper path. If smaller
items are offset from the center they will not be detected. This will cause feeding issues
and paper jams. The ratio between the smallest and largest page in the stack should be
no more than 1.5.
• Page thickness
– U-Turn Path: 27~105 g/m
2
(7 ~ 28 lbs)
– Straight path: 27~ 413 g/m
2
(7 ~ 110lbs)
To Next Page
Loading...
Need help?
General