Troubleshooting
WorkCentre 7500 Series Multifunction Printer 243
User Guide
Troubleshooting Print-Quality Problems in the Printer
If you have print-quality problems when printing a Demo Page or the Configuration Report from the
control panel, the problem is in the printer.
To find the source of the problem:
1. At the control panel, print the Troubleshooting Print-Quality Pages. For details, see Printing the
Troubleshooting Print Quality Pages on page 241.
2. If the prints are too light to see print details, verify the following:
The printer is loaded with undamaged, dry supported paper.
The toner levels of one or more of the toner cartridges is not too low.
3. If the pages are printed with a solid color, one or more of the drum cartridges could be defective.
Correct the problem before continuing.
4. If the colors of the pages do not match your expectations, run the control panel Print Calibration.
5. Compare the print-quality problems in your document to each of the examples in the
Troubleshooting Print-Quality Pages.
If you find a match in the Troubleshooting Print-Quality Pages, look in the Solutions column for the action
to take to resolve the problem.
If the problem persists, go to www.xerox.com/office/WC75xxsupport for online support information.
Performing the Print Calibration Procedure
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Troubleshooting > Calibration > Print Calibration.
3. Follow the onscreen instructions to run the Print Calibration procedure.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
