Xiaomi roborock User Manual

Using
Partial cleaning
When the device is in the standby mode or paused, press the button for partial cleaning,
after which the device will remove the central area of the room with a size
of 1.5x1.5 m. When the device nishes its work, it will automatically return to its original
position, completing the cleaning of a certain zone.
Attention: if the device is paused, pressing the partial cleaning button stops cleaning the
previous zone.
Pause
While the device is operating, press any button on the vacuum cleaner to stop it.
Press the Power / Cleaning button to continue cleaning;
Press the Charging button to bring the vacuum cleaner back to the docking station for
recharging and stop the current cleaning.
Attention: if the device is paused, you turn on the function of returning to the docking
station, the current cleaning of the premises is over.
If cleaning is necessary, add water or rinse the wet cleaning attachment, rst press any
button to pause the device, then remove the wet cleaning module from the vacuum
cleaner, add water or rinse an attachment. After this, install the module for wet cleaning
back and press the Power / Clean button to continue cleaning.
Troubleshooting
If a malfunction occurs during the cleaning process, the ring-shaped indicator of the device
will ash rapidly in red and the voice message will turn on. To solve this problem, see the
«Troubleshooting» section.
Attention:
- If the device does not work for 10 minutes due to a problem, it automatically enters sleep
mode.
- If a malfunction occurs during charging on the dock, the device stops pre-cleaning.
Sleep mode
If the device does not perform any actions within 10 minutes, it can automatically switch to
sleep mode. In this case, the ring-shaped indicator ashes once every few seconds.
To awaken the device, press any button on the vacuum cleaner.
Attention:
- The device does not enter sleep mode if it is on recharging
on the docking station.
- If the device is in sleep mode for more than 12 hours, it automatically turns o󰀨.
Setting cleaning time
Thanks to the mobile application, you can set the cleaning time of the room. In this case,
the vacuum cleaner automatically starts to clean at the set time, and after the cleaning is
completed, it automatically returns to the docking station.
Reset Wi-Fi settings
If you replace the router, forget the password, or if there are any other situations, that
caused a problem with connecting the device to the mobile application, open the top panel
of the vacuum cleaner to see the Wi-Fi indicator, simultaneously press and hold the Partial
cleaning and Charging buttons, You will hear a voice alert when you reset your Wi-Fi
settings. Wait until the Wi-Fi indicator starts ashing slowly, indicating a successful reset.
Setting cleaning zone
Using the mobile application, set the cleaning zone, after which the vacuum cleaner will
clean only the zone, dened by you.
Setting the end point
Using the mobile application, set the desired point on the map of the room, the device will
automatically determine the route to achieve the goal.

Xiaomi roborock Specifications

General

Brand	Xiaomi
Model	roborock
Category	Vacuum Cleaner
Language	English