(prompt "ST" on the screen)
Press
long
the 2/SEL button (ca. 2
seconds long) several times to switch
between following settings:
1.
AF function on/o
(prompt "AF ON" on the screen)
2. TA function on/o
(prompt "TAOFF" on the screen)
3.
PTY function on/o
(prompt "PTYOF" on the screen)
4. Trac announcement (TA) settings
(prompt "TASEK" on the screen)
5.
Sound during frequency band scan
(prompt "PISOUND" on the screen)
6.
Searching time for stations with PI
label
(prompt "RETUR L" on the screen)
7. Key sounds
on/o
(prompt "BEPON" on the screen)
As soon as you choose one of the
functions to set use the button VOL-
/ VOL+ to maximize/minimize the
corresponding factor.
* If the preset EQ is active, the BASS
and the TREBLE settings can not be
changed - these options are unavailable
in the menu. To change the BASS/
TREBLE settings you have to turn the
EQ preset o rst.
Basic functions
Mode choice
Press the ? /MOD button on the
front panel or the MOD button on the
remote control to switch between the
modes: Radio, AUX, USB and SD.
Loudness
Use the VOL- / VOL+ button on the
front panel to boost or to reduce the
loudness.
Settings
Press the 2/SEL button (perhaps ca.
2 seconds long) several times to switch
between following settings:
1.
LED color settings
(prompt "AUTO" on the screen)
2.
Bass settings*
(prompt "BAS" on the screen)
3.
Treble settings*
(prompt "TRE" on the screen)
4.
Balance settings
(prompt "BAL" on the screen)
5.
Fade settings
(prompt "FAD" on the screen)
6.
Loudness on/o
(prompt "LOUOF" on the screen)
7.
Equalizer on/o
(prompt "EQOFF" on the screen)
8.
Local function on/o
(prompt "DX" on the screen)
9.
Stereo/Mono switch
To Next Page
Loading...
Need help?
General
