A80 BT Intelligent Diagnosis System
is 80-105 degrees Celsius, the operating voltage and time of each sensor
and actuator should be.
Actuation components test: The main purpose is to determine
whether these actuator components are working properly.
Special Features: Special models only.
（2）Toolbar function buttons description
Returns to the previous interface.
Click to record the data, click again to send
your feedback to XTOOL service center.
4.3 Read ECU：
（1）This function is to read the ECU version information, in some
of the electronic control displayed as "System identification" or "System
Information" menu, the meaning is the same., It reads the ECU related
software, hardware version and part number and other information. As
shown in the following figure.
To Next Page
Loading...
Need help?
General
