EPB RESET
Electronic Parking Brake (EPB) System reset is a popular special
function. You can use this function to reset the electronic parking
brake system and brake pads, which also supports the brake pad
replacement (retraction, release of the brake pump), G-sensor and
body angle calibration. This function has multiple uses and can
safely and effectively maintain the electronic brake system. These
applications include deactivating and activating brake control
systems, assisting in controlling brake fluid, opening and closing
brake pads, and setting brakes after replacing brake discs or
brake pads, etc.
1. If the brake pad wears the brake pad sense line, the brake pad
sense line sends a signal sense line to the on-board tablet to
replace the brake pad.
After replacing the brake pad, you must reset the brake pad.
Otherwise, the car alarms.
2. Reset must be performed in the following cases:
The brake pad and brake pad wear sensor are replaced.
The brake pad indicator lamp is on.
The brake pad sensor circuit is short, which is recovered.
The servo motor is replaced.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
