a) When performing ABS Bleeding, it is necessary to unscrew the exhaust screw of the
ABS pump.
b) After completing the tire pressure sensor learning, it takes a while for the fault light
to go out.
c) Tire pressure imbalance will also cause the tire pressure light to light up.
GEARBOX MATCH
After changing the gearbox or changing the gearbox ECU, you
need to use the gearbox matching function to re-match the engine
and the gearbox.
*Cautions!
Before resetting the gearbox, please check the gearbox control
unit to ensure that there is no fault code. If there is a fault code,
the gearbox memory function cannot be reset. Please road test
after reset.
GEAR LEARNING
The crankshaft position sensor learns crankshaft tooth machining
tolerance and saves to the tablet to more accurately diagnose
engine misfires. If tooth learning is not performed for a car
equipped with Delphi engine, the MIL turns on after the engine is
started. The diagnostic device detects the DTC P1336 'tooth not
learned'. In this case, you must use the diagnostic device to
perform tooth learning for the car. After tooth learning is successful,
To Next Page
Loading...
Need help?
General
Weight and Dimensions
