33FT-7100M Operating Manual
Memory Offset Tuning
Once you have recalled a particular memory channel, you may easily tune off that channel, as
though you were in the “VFO” mode.
1. With the FT-7100M in the “MR” (Memory Recall) mode, select the desired memory
channel.
2. Now press the
[
MHz
]
key momentarily; the “ ” icon will appear on the display..
3. Rotate the Main Dial knob (or press the microphone’s
[
UP
]
/
[
DWN
]
buttons), as desired, to tune to a new fre-
quency. The synthesizer steps selected for VFO opera-
tion on the current band will be the steps used during
Memory Tuning.
4. If you wish to return to the original memory frequency, press the
[
V/M
]
key momentarily.
The “ ” icon will disappear..
5. If you wish to store the new frequency set during Memory Tuning, just press and hold in
the
[
V/M
]
key for 1/2 second, select a new memory (if desired), then press and hold in the
[
V/M
]
key for 1/2 second again.
MASKING A MEMORY
There may be situations where you want to “Mask” memories so they are not visible during
memory selection or scanning. For example, several memories used only in a city you visit
infrequently may be stored, then “Masked” until you visit that city, at which time you can
“Unmask” them for normal use.
1. Press and hold the
[
V/M
]
key for 1/2 second.
2. Rotate the Main Dial knob (or press the microphone’s
[
UP
]
/
[
DWN
]
buttons) to select
the memory channel to be “Masked” from view.
3. Press the
[
REV
]
key momentarily. The display will revert to memory channel #1, and the
previously-selected memory will now be “Masked.”
4. To unmask the hidden memory, repeat the above procedure: press and hold in the
[
V/M
]
key for 1/2 second, select the masked memory’s number, then press the
[
REV
]
key mo-
mentarily to restore the memory channel’s data.
If you over-write a “masked” memory channel, the original contents of the memory
will be lost.
MEMORY OPERATION
RECALLING MEMORIES
To Next Page
Loading...
Need help?
General
