Yaesu FT-817ND User Manual

9FT-817ND Operating Manual
INSTALLATION
EXTERNAL POWER CONNECTIONS
The FT-817ND may be connected to an external 13.8 Volt DC power source providing at
least 3 Amps of continuous-duty current.. The supplied E-DC-6 DC cable may be used for
DC connections.
While connected to an external DC source, if you have installed the supplied FNB-85 Ni-
MH Battery Pack, the E-DC-6 connection to the external DC power source will allow op-
eration of the FT-817ND while charging of the FNB-85 is in progress.
When making DC power connections, be absolutely certain to follow the markings on the E-
DC-6 so as to ensure proper polarity of the connection to the power supply. Connect the RED
AND
BLACK wire to the Positive (+) power supply terminal, and connect the SOLID BLACK wire
to the Negative (-) power supply terminal.
Notice
Be extremely careful when making power supply connections. Use only a 13.8 Volt
DC Supply, and carefully observe the proper electrical polarity. Serious damage may
result if these precautions are not observed.
The Limited Warranty on this product does not cover damage caused by improper
power supply connections, or improper power supply voltage.
FT-817ND

Yaesu FT-817ND Specifications

General

Output power	1 W
Frequency range	30 - 100000 MHz
Channels quantity	208 channels
Display type	LCD
Product type	Portable CB radio
Product color	Black
Housing material	-
Battery type	AA
Number of batteries supported	8

Weight and Dimensions

Depth	165 mm
Width	135 mm
Height	38 mm