Yaesu FT-857D User Manual

98 FT-857 Operating Manual
MENU MODE No•008
[
ARTS BEEP
]
Function: Selects the ARTS beep mode.
Available Values: OFF/RANGE/ALL
Default: RANGE
OFF: No alert beeps sound; you must look at the display to determine current ARTS
status.
RANGE: A high tone beep will sound when the transceiver first detects that you are within
range, and a low beep will sound when the other station goes out of range.
ALL: A high tone beep will sound every time a polling transmission is received from
the other station, and a low beep will sound once when the other station goes out
of range.
MENU MODE No•009
[
ARTS ID
]
Function: Enables/disables the CW identifier during ARTS operation.
Available Values: ON/OFF
Default: OFF
MENU MODE No•010
[
ARTS IDW
]
Function: Stores your callsign into the CW identifier. Up to ten characters may be stored.
The storage procedure is as follows:
1. Press the SELECT knob momentarily to initiate callsign storage (the first character
location of the callsign will be underlined).
2. Rotate the DIAL knob to select the first letter/number of your callsign, then rotate the
SELECT knob one click clockwise to save the first letter/number and move to the next
entry position.
3. Repeat the previous step as many times as necessary to complete your callsign.
4. Press the SELECT knob to save your completed callsign and exit.
Default: YAESU
MENU MODE No•011
[
BEACON TEXT 1
]
Function: Stores the message for the Beacon. Up to 40 characters may be stored. The stor-
age procedure is as follows:
1. Press and hold in the
[
FUNC
]
key for one second to enter the Menu mode.
2. Rotate the SELECT knob to select Menu Mode No-011
[
BEACON TEXT 1
]
.
3. Press the SELECT knob to enable storage of the Beacon Text (the first character loca-
tion will be underlined).
4. Rotate the DIAL to select the first character (number or letter) in the Beacon Text you
wish to store, then rotate the SELECT knob one click clockwise to move to the next
character.
5. Repeat step 4 as many times as necessary to complete the Beacon Text.
6. If the Beacon Text is less than 40 characters or more than 40 characters, see page 90 for
details.
MENU OPERATION

Yaesu FT-857D Specifications

General

Modes	SSB, CW, AM, FM, WFM
Impedance	50 Ohms, unbalanced
Supply Voltage	13.8 V DC ±15%
Frequency Range	420-470 MHz
Power Output	100 W (HF/50 MHz), 50 W (144 MHz), 20 W (430 MHz)
Current Consumption	22 A (maximum)
Dimensions	155 x 52 x 233 mm (6.1" x 2.0" x 9.2")
Weight	2.1 kg
Channels	200
Receiver Sensitivity	0.2 μV (SSB/CW)