18 FT-857 Operating Manual
RECEIVER ACCESSORIES
(
TAPE RECORDER ETC.
)
Connection of a tape recorder or other such receiver accessory is
easily accomplished by using the DATA jack’s Data Out (1200 bps)
terminal (Pin 5) and Ground (Pin 2). The audio output is fixed at
100 mV, with an impedance of 600 W.
ADJUSTING THE FRONT FEET
The two front feet of the transceiver allow the transceiver to be tilted upward for better
viewing. Simply fold both feet forward to raise the front of the transceiver, and fold them
back against the bottom case to lower the front of the FT-857.
INSTALLATION
DATA OUT
1200bps
GND
To Next Page
Loading...
Need help?
General
