18
3. Press the [GM] key, then rotate the DIAL knob to select “DG-ID RX”.
4. Press the [GM] key, then rotate the DIAL knob to set the receive DG-ID (DG-ID
RX).
5. Press and hold the [DISP] key, to save the setting and return to normal
operation.
The setting of the transceiver is complete.
Start operation of Portable Node
1
. Press the [X] key on the portable node's transceiver.
The “
X
” icon flashes on the upper left of the LCD screen.
• The display screen example uses the “Access Point” screen. In “Direct Operation”,
“DIRECT” is displayed instead of frequency
• If the “
X
” icon does not blink when the [X] key is pressed, communication between the
transceiver connected to the PC and the WIRES-X software has not been established,
so check the cable connection and USB driver installation.
• To cancel the connection, press and hold the [X] key.
2
. When the operation of the portable node is started, the “
X
” icon changes from
blinking to lit and the Node ID and the city of its own station are displayed.
Depending on the history of the previously connected node on the internet and the
current connection status of the portable node, one of the following four screen is
displayed.
If the portable node is not connected to a node or a room on the Internet
①
When connection history is not stored
The lower connection destination display will be blank.
②
When connection history is stored
The ID of the previous connected the Node or Room will blink.
Press the PTT switch or touch [blinking connection ID] to connect.
To Next Page
Loading...
Need help?
General