36
6. Click the [Levels] tab on the “Speakers Properties”
screen.
7. Adjust the volume level of “microphone” so that the
volume of the other station operating in digital mode will
be easy to hear.
8. Click the “×” button at the top right of the “Volume Mixer”
window to close.
The audio level adjustment of Direct Operation is completed.
FT2D Direct Operation dedicated function
FT2D has a setting function related to analog audio that can be used only in Direct Operation (Portable HRI Mode).
Output of analog voice (uplink) setting
Set whether to output audio to the analog station when talking by pressing the PTT switch.
Each time you press the [V/M] key, it switches between “ON” and “OFF”.
OFF
：
Does not output sound to the analog station.
（
Default setting
）
Turn it off when you do Internet communication only in digital mode.
ON
：
Audio output to the analog station. “
*
” Is displayed on the right side of the call sign of the screen.
Always turn on Internet communication when using the analog communication in the analog mode.
• When set to “OFF”, the other station operating in analog mode cannot hear this voice.
• When set to “ON”, your voice is output from the PC or FT 2D speaker.
Level adjustment of analog audio output (uplink)
Since the level of the analog sound is set with the personal computer, it is not normally necessary to adjust this level.
If you turn the VOL knob while pressing the PTT switch while the analog audio output (uplink) setting is “ON”, it will
be displayed as LEVEL XX (XX: 0 to 31) and the volume level of the analog audio to be sent to the other station You
can adjust. (The default setting is 10.)
To Next Page
Loading...
Need help?
General