35
Adjust speaker output level of PC
Adjust the volume level so that the “VOL bar graph” is halved by turning the VOL knob of FT2D, then make the following
adjustments. Also, when using FT2D as a transceiver of a Portable Digital Node station, adjust it so that it is almost the same
volume level.
1. Click the “OS Volume Mixer”.
The WINDOWS “Volume Mixer - Speakers” window
opens.
2. Click the [Start] in the “Test Tone” area.
A test tone is output.
3. Adjust the volume level of “WIRES-X” on the “Volume
Mixer” screen so that the test sound that you hear from
the PC 's speaker will be easy to hear.
When adjustment is completed, click the [Start] button
again, to stop the test sound.
• If the speaker output is muted, click
the icon “
” at the bottom of the slider to
release the mute.
• If the volume level of “Speaker/Headphone” is
decreasing, adjust the volume so that it is easy to
hear.
4. Adjust the volume level of the “microphone” on the
“Volume Mixer” screen so that the voice of the partner
station operating in the digital mode will be easy to hear.
When the adjustment is completed, proceed to step 8.
Depending on your computer, this setting item may be
missing in the volume mixer. In this case, proceed to
step 5.
5. Click the “Speakers” icon on the “Volume Mixer”
screen.
The “Speakers Properties” screen opens.
To Next Page
Loading...
Need help?
General