To Next Page

To Previous Page

4-20

EML02011

CHECKING POWER TRIM AND TILT

SYSTEM

8 Never get under the lower unit while it

is tilted, even when the tilt-support

lever is locked. Severe injury could

occur if the outboard accidentally falls.

8 Make sure no one is under the out-

board before performing this test.

1) Check the power trim and tilt unit for

any sign of oil leaks.

2) Operate each of the power trim and

tilt switches on remote control and

engine bottom cowling (If equipped)

to check that all switches work.

3) Tilt up the motor and check that the

tilt rod and trim rods are pushed out

completely.

4) Use the tilt-support lever to lock the

motor in the UP position. Operate the

tilt down switch briefly so the motor

is supported the tilt-support lever.

5) Check that the tilt rod and trim rods

are free of corrosion or other flaws.

6) Activate the tilt-down switch until the

trim rods have gone completely into

the cylinders.

7) Activate the trim-up switch until the

tilt rod is fully extended. Unlock the

tilt-support lever.

8) Operate the motor to tilt down. Check

that the tilt rod and trim rods operate

smoothly.

411024

64C-9-76 (E,F,ES) 4C 4/25/0 3:10 PM Page 166

Yamaha 100A User Manual

Other manuals for Yamaha 100A