2-16
GB
301022
EMD63210
TOP COWLING LOCK LEVERS
V6 engine type
To remove the engine top cowling, pull
up the front and rear lock levers. Then lift
off the cowling. When replacing the cowl-
ing, check to be sure it fits properly in the
rubber seal. Then lock the cowling again
by moving the levers downward.
EMD64010
TOP COWLING RELEASE LEVER
V4 engine type
The top cowling can be removed by oper-
ating the cowling release lever.
Pulling the front lever unlocks the top
cowling for removal.
When refitting the top cowling:
1) Set the top cowling straight down
onto the engine, being careful to
avoid catching spark plug leads or
other wires.
2) Align the three cowling hooks with
the locks on the bottom cowling.
3) Press down on the top of the cowling
at the front and both sides of the back
until the three locks click.
4) To make sure the cowling is locked
properly push the cowling from each
side. If it lifts, repeat step 3.
V6
V6
V4
V4
64C-9-76 (E,F,ES) 2 4/25/0 2:53 PM Page 54
To Next Page
Loading...
Need help?
General
