3-11
GB
EMU00854
PROCEDURE FOR TILLER CONTROL
MODEL
4) Place the gear-shift lever in the neu-
tral position.
NOTE:
The start-in-gear protection device pre-
vents the engine from starting except
when in Neutral.
5) Place the throttle control grip in the
“START” position.
001367
6) Attach the engine stop switch lanyard
to a secure place on your clothing, or
your arm or leg. Then, install the lock
plate on the other end of the lanyard
in the engine stop switch.
w
8 Attach the engine stop switch lanyard
to a secure place on your clothing, your
arm or leg while operating.
8 Do not attach the lanyard to clothing
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing it from functioning.
8 Avoid accidentally pulling the lanyard
during normal operation. Loss of
engine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly.
This could cause people and objects in
the boat to be thrown forward.
To Next Page
Loading...
Need help?
General
